GSS NY Branch
59-43 Fresh Meadow Lane
Fresh Meadows, NY 11365
Mon. – Sun:
8:30am - 5:30pm
GSS NY Branch
59-43 Fresh Meadow Lane
Fresh Meadows, NY 11365
Showing 145–162 of 173 results
| Input Voltage | 12 VDC from host controller |
|---|---|
| Input Current (not including devices) | Standby: 30 mA Maximum: 135 mA |
| Number Reader Ports | 4 |
| Number of Inputs | 4 |
| Output Relays | 4 x 5 A with N.O., N.C. and COM contacts Form-C Relays |
| Inputs Voltage | 5 VDC maximum voltage |
| Reader Output Voltage | 12 VDC |
| Maximum Reader Current | 300 mA |
| LED Control Output | Open collector, active low |
| Tamper Output | 5 VDC maximum voltage, optical anti-tamper sensor |
| Supported Formats | Various, please refer to AxTraxNG User Guide or the AxTraxPro User Guide |
| Power LED | Active when mounted correctly on the host controller (AC-425) |
| Output LEDs | Four LEDs; Each output LED is active when an output relay is activated and N.O. to COM contacts are shorted |
| Dimensions | 115 x 75.9 x 32.5 mm (4.52 x 2.98 x 1.28 in.) |
| Weight | 98.2 g (0.21 lb) |
| PRODUCT WARRANTY | 2-year limited product warranty |
| Input Voltage | 12 VDC |
|---|---|
| Input Current (not including devices) | Standby: 30 mA Maximum: 135 mA |
| Number of Outputs | 4 |
| Number of Inputs | 8 |
| Output Relays | 5 A @ 30 VDC with N.O., N.C. and COM contacts Form-C Relays |
| Inputs Voltage | 5 VDC maximum voltage |
| Input Type | Selectable: Normally Open, Normally Closed, Non-supervised (two states), supervised with one resistor (three states), supervised with two resistors (four states) |
| Power LED | Active when mounted correctly on the host controller |
| Output LEDs | Four LEDs; each output LED is active when an output relay is activated and N.O. to COM contacts are shorted |
| Dimensions | 100 x 75.9 x 32.5 mm (3.93 x 2.98 x 1.28 in.) |
| Weight | 98.2 g (0.21 lb) |
| PRODUCT WARRANTY | 2-year Limited Product Warranty |
| Input Power | 12 VDC from power adapter |
|---|---|
| Power Consumption | Typical: 70 mA Maximum: 100 mA |
| LED | Green indicates network status Red indicates power supply |
| Hardware Protocols | TCP, UDP, IP, ARP, ICMP, Ethernet MAC |
| Network Interface | 10/100 Base-T Ethernet (Auto-Detection) RJ-45 jack for LAN connection |
| Serial Port | D9 male connector RS-23 |
| Data | 1,4,6,7,8,9 –NC 2 – Rx 3 – Tx 5 – GND signal |
| MCU | 8-bit MCU and 32K FLASH |
| Serial Line Format | 8-N-1, 8-O-1, 8-E-1, 7-O-1, 7-E-1 |
| Serial Flow Control | None, XON/XOFF |
| Transmission Speed | 1200 bps ~ 230.4 Kbps |
| Operating Environment | Indoor use |
| Dimension | 110 x 63 x 39 mm (4.3 x 2.5 x 1.5 in.) |
| Weight | 92 g (3.25 oz.) |
| SYSTEM COMPONENTS | The MD-N32 is compatible With Rosslare's controllers AC-215, AC115, Fingerprint Reader AYC-W6500, as well as intrusion alarm panels AuraSys and HomeLogiX. |
| PRODUCT WARRANTY | 2-Year Limited Product Warranty |
| Operating Voltage Range | Far unit: 12–24 VAC, 15–24 VDC Near unit: 13.8 VDC from controller's power supply/wall adapter |
|---|---|
| Input Current, Max | Standby: 70 mA Maximum: 160 mA |
| Battery Charger | 12 V Sealed Lead-Acid, up to 7 Ah (far unit only) |
| Maximum Range | Indoors: 70 m (230 ft), Outdoors: 300 m (985 ft) Range depends on RF related environmental conditions |
| Response Time | Up to 500 ms with Rosslare’s access controllers and readers Response time depends on RF link quality, number of doors used, and controller and reader response time |
| Output Relays | Far unit: One 5 A Form-C relay Near unit: Two 1 A Form-C relays |
| Output Types | Dry contact and open collector |
| Communications | Bi-directional RF, narrow band. Fast anti-collision rolling code protocol with data protection. Available in HR-869 MHz and GR 433 MHz bands, with four selectable channels |
| Data Transfer | Card and PIN, lock commands, REX, door monitor, LED control and reader tamper |
| Supervisory & Alerts | Full supervision over the remote unit Alert outputs at the Near unit for supervision failure, system tamper, reader tamper, low battery, and power failure |
| Supported Card transmission formats | Wiegand 26-, 32- ,34- , and 40-Bit, 26-Bit with Facility code, 32-Bit Reverse |
| Supported PIN code formats | Single key Wiegand 6-Bit (Rosslare format with parity), Single key Wiegand 8-Bit, 4 keys binary Wiegand 26-Bit, 1 to 5 keys, Wiegand 26-Bit, 6 keys BCD and parity bits |
| Operating Temperature | -10°C to 50°C (14°F to 122°F) |
| Operating environment | Indoor use |
| Dimensions | 13 x 8.7 x 3.2 cm (5.1 x 3.42 x 1.26 in.) |
| Weight | 155 g (5.5 oz) |
| SYSTEM COMPONENTS | Rosslare’s Access Control Panels Rosslare’s 26-Bit readers |
| PRODUCT WARRANTY | 2-year Limited Product Warranty |
| Switch Mode PS Input Voltage | 100 ~ 240 VAC,50 ~ 60 Hz from main power Maximum input current: 1.6A |
|---|---|
| Switch Mode PS Output Voltage | 15 VDC,4 A (60 W) to the PM-10 power management board |
| Power Output from PM-10 | Isolated PTC fused output, providing 13.8 VDC, 2A |
| Battery Charger Output | 13.8 VDC, 300mA for 12 VDC, 7Ah lead acid battery |
| Built-In Speaker (Audio Indication) | 0.5 W, 8Ω |
| LED Indicators | 2 LED for Power Outputs 1 and 2 Green LED shows power status visible when case is closed |
| Light Bar/Tamper Switch | 0.3 W for LED light bar |
| Lock Type | Mini-cylinder lock with 2 keys |
| Enclosure Dimensions | 404 × 346 × 101 mm (15.9 x 13.6 x 4.0 in.) |
| Weight | 4.5 kg (9.92 lb) |
| Product Warranty | 2-year limited product warranty |
| SMPS Input | 110 – 240 VAC, 50/60 Hz, 1.5 A |
|---|---|
| SMPS Output | 15 VDC, 4 A |
| PM-05 Input | 15 VDC, 4 A |
| PM-05 Output | 14.5 VDC, 2 A (CH1/CH2) |
| PM-05 Battery Charge current | 1.5 A |
| MD-25TB Input | 12 VDC, 2 A |
| MD-25TB Output | 12VDC 1 A max combined ACU output and lock power supply |
| MD-25TB Lock Output | 5 A Form C, SPDT Relay Max Switched Current: 5 A Max Switched Voltage: 150 VDC or 300 VAC UL Rating: 5 A at 30 VDC or 5 A at 125 VAC |
| MD-25TB Auxiliary Output | 5 A Form C, SPDT Relay Max Switched Current: 5 A Max Switched Voltage: 150 VDC or 300 VAC UL Rating: 5 A at 30 VDC or 5 A at 125 VAC |
| MD-25TB Speaker Output | 0.25 W, 8 Ω (minimum) |
| MD-25TB LED indicators | Power Status • Red shows power on • Off shows power off |
| Operating Environment | Indoor |
| Enclosure Dimensions | 228 x 224 x 84 mm (9.0 x 8.8 x 3.3 in.) |
| Weight | 2.21 kg (4.87 lb) |
| COMPATABILE DEVICES | Rosslare AYC readers |
| PRODUCT WARRANTY | 2-year limited product warranty |
| Color | Black ,Blue ,Gold ,Natural ,Red ,White |
|---|---|
| Switch Voltage | 0 VDC to 30 V AC/DC |
| Switch Current | 1 A (max) |
| Wire Leads | 2 x 24 AWG 280 mm (11.0 in.) wires |
| 2-Wire Interface | No polarity |
| Button Life | Up to 20 million cycles |
| Impulse Time | >50 ms (on actuation) |
| Operating Temperature Range | -40°C to 70°C (-40°F to 158°F) |
| Operating Humidity | 0% to 99% Wet – Meets IP68 (waterproof) |
| Operating Environment | Indoor and Outdoor |
| Dimensions | Height: 19.5 mm (0.8 in.), Diameter: 29.5 mm (1.2 in.) |
| Standard Thread | 22 mm (0.9 in.) |
| Weight | 22 g (0.8 oz) |
| PRODUCT WARRANTY | Lifetime Warranty |
No account yet?
Create an Account